Proface APL3000B - Node Box PC - Manual (Page 49)

PS-3000B Series Hardware Manual
2-26
• About Switches
Switch
Location
Switch Name Description
A System Set SW (SW1)
10-point dip switch. For System Set SW and factory settings
details, see Table (1).
B
Serial Mode Select SW
(SW2)
10-point dip switch. Designates COM2 communication settings.
For Serial Mode Select SW details, see Table (2).
Factory Settings: For RS-232C
C Reset SW
„Power Button Mode
In advance, turn ON the System Set SW No.6.
For Windows
®
2000, the mode of [When I press the power
button on my computer] that is selected from PS-B’s start menu-
[Settings]-[Control panel]-[Power Options]-[Advanced]-[Power
buttons] is operated when pressing the Reset SW.
For Windows
®
XP, the mode of [When I press the power button
on my computer] that is selected from [Control panel]-
[Performance and Maintenance]-[Power Management option]-
[Advanced] is operated.
• PS-B restarts when pressing the switch at the Soft OFF
*1
state (the
Power LED / RAS Status Lamp is blinking in green).
„Reset Switch Mode
In advance, turn OFF the System Set SW No.6. PS-B restarts
when pressing the Reset SW.
*1 The Soft OFF refers to the state that Windows
®
has been shut down and the power is
provided only for the electric circuit to boot system. This Soft OFF State is different
from what is System Standby set by Windows
®
.
ON
12345678910
B
10
ON
A
123456789
IDE I/F
C
SW1
SW2
PS3001-BD Inside of the top