Proface APL3000B - Node Box PC - Manual (Page 62)

Chapter 3 Installation and Wiring
3-7
(2) Unscrew the screws (2) from the Memory Slot Cover, and remove the cover.
(3) Angle the main memory module down slightly, and push it in until the connector pins mate with the
module’s pins. Then, lower the module until it is horizontal and insert it completely into the connector.
This connector is shown in (2).
(4) Push in the main memory module until the stopper snaps into place.
(5) Replace the Memory Slot Cover and reattach two (2) attachment screws.
The torque should be 0.5 to 0.6N
•m.
(6) For PS3000-BA, replace the Expansion Board Cover and reattach two (2) attachment screws lastly. The
torque should be 0.5 to 0.6N
•m.
3.2.2 Expansion Board (PCI) Installation
A PCI board, which is sold on the market, can be installed on PS3000-BA.
(1) Turn OFF the power switch of the PS-B and remove the power cable. Place the PS-B on a flat, level
surface facing the top side upwards.
• The Expansion Board (PCI) is corresponding to PS3000-BA units.
• The maximum size allowed for a PCI board is 106.68mm [4.2in.] x 174.63mm
[6.88in.] .
Main Memory
Installation
Area
(This figure is PS3000-BA.)
Main Memory
Installation
Area
(This figure is PS3001-BD.)
Connector
Main Memory
Stopper
1
2