Proface APL3000B - Node Box PC - Manual (Page 29)

PS-3710A / PS-3711A Reference Manual
2-6
Transfer Mode
Specifies a method of transferring data. When the [Type] is [None], nothing is displayed. When [Type] is
[Auto], the selection is disabled. In other cases, select from [Standard], [Fast PIO 1], [Fast PIO 2],
[Fast PIO 3], [Fast PIO 4], [FPIO 3/DMA 1], or [FPIO 4/DMA 2].
Ultra DMA Mode
Specifies a Ultra DMA mode for the Hard drive. When the [Type] is [None], nothing is displayed. When
[Type] is [Auto], the selection is disabled. In other cases, select from [Disabled], [Mode 0], [Mode 1],
[Mode 2], [Mode 3], [Mode 4], or [Mode 5].
2.2.2 Advanced
Installed O/S
Specifies a type of OS of the unit. Select from [Other], [Win95], [Win98], [WinMe], or [Win2K/XP]. The
factory default setting is [Win2K/XP].
Reset Configuration Data
Specifies whether you want to reset the Plug & Play information which is recorded in the Extended System
Configuration Data (ESCD) Block of the CMOS RAM, when the system boots up next time. Select from
[Yes] or [No]. The factory default setting is [No].
Large Disk Access Mode
Specifies the access mode. When you use UNIX or NetWare for OS, the setting should be [Other]. Select from
[Dos] or [Other]. The factory default setting is [Dos].