1 problems and countermeasures, 1 problems and countermeasures -2, 2 4.1 problems and countermeasures – Proface APL3000B - Node Box PC User Manual

Page 95

Advertising
background image

PS-3710A / PS-3711A Reference Manual

4-2

4.1

Problems and Countermeasures

Problem

Countermeasure and reference page

Nothing appears on the screen.

Is the power cable connected properly?

Is the power supply/voltage within the range of the
specifications?

Is the backlight lit? If the backlight is burnt out, replace it.

Does the status LED illuminate in green?

The OS does not operate
properly.

Is [Type] in [Primary Slave] set to [Auto] in the IDE setting?

Did you connect a new hard disk drive or commercial USB
memory which does not require boot-up?

If this symptom occurs, setting [Power on Delay] to [Enabled]
may solve the problem.

“Delayed Write Failed”
occurs frequently.

When some of the following conditions occur simultaneously,
there is a high probability that the PS-A has failed while
writing to files, resulting in this error.
• The same file is frequently accessed (opened, read,

written, etc.).

• The amount of implemented memory is small and cache

memory is insufficient.

• The file is highly fragmented.
• The I/O load to the disk is high.
• Delay writing fails.
Try performing maintenance on the drive. If the problem
continues, replace the drive.

I did not shut down or
reboot the unit, but the
“CMOS CHECK SUM
ERROR” occurred.

The clock data back-up battery may be exhausted.
Replace the battery. Note that when the battery is removed,
the BIOS settings will be lost so you need to set up the BIOS
again after replacing the battery.

The battery may be exhausted more quickly under the
following conditions.
• The temperature of the surrounding environment

frequently changes from low to high.

• The connected expansion board consumes the clock data

back-up battery quickly.

SEE

PS-3710A/3711A Hardware Manual

3 Hardware Installation

SEE

PS-3710A/3711A Hardware Manual

2 Specifications

SEE

PS-3710A/3711A Hardware Manual

4 Maintenance

SEE

If the status LED does not illuminate, contact your
local PS-A distributor.

SEE

„

Primary Master / Primary Slave / Secondary

Master / Secondary Slave (page2-5)

SEE

2.2.5 Boot (page2-28)

SEE

Power On Delay (page2-8)

Advertising