Yokogawa DAQWORX - Manual (Page 123)

5-27 IM WX104-01E
Conf
gur
ng the DX100/DX200/MV100/MV200
1
2
3
4
5
6
7
8
9
Index
5.7 Sendng the Setup Data to the DX/MV
The method used to send the data varies depending on whether a CONFIG file or setup
data file is being transmitted.
CONFIG fle
The following two methods are available:
• Selectng from the toolbar
The setup data are sent when [File] - [Store] is selected.
• Clckng the [X] button
When the Configurator is closed by clicking the [×] button, a confirmation dialog box is
displayed.
To send the new setup data to the DX100/DX200/MV100/MV200, click the [Yes]
button.
Otherwise, click the [No] or [Cancel] button.7
If the DX100/DX200/MV100/MV200 is acquiring data to the memory, a message “Now
Memory & Math sampling. Can’t store setting” is displayed. The data will not be sent
in this case.
Setup data fle
DX/MV folder
1. Stop the data acquisition to the memory.
2. Dra g and drop the file onto the CONFIG
ico n of the DX/MV folder
The contents of the setup data file (*.PNL) located on the DAQ Desktop can be
transmitted. If the DX100/DX200/MV100/MV200 is acquiring data to the memory, the
data will not be sent in this case.
Note
Of the network settings in the [Setup] tab, the following items are not transmitted.
• [IP Address] under the [TCP/IP] tab
• All settings under the [Serial], [Modbus master], and [Web] tabs