Renkus-Heinz VAX15S - Manual (Page 10)

Horizontal Arrays
The skillful design, complementary cabinet angles and
tightly controlled dispersion that allow the sonic out-
puts of VARIA array modules to be smoothly mixed
to obtain the desired coverage perform just as well in
horizontal arrays as they do in vertical line arrays.
Joining two VA101-22 22.5º modules together in a
horizontal array or cluster produces a seamless 45º
horizontal pattern; use three 22.5º modules for 67.5º
of horizontal coverage and 4 for 90º. Or use 6 VA101-
22 modules for 135º of horizontal coverage.
Assembly is a snap. Stand the cabinets on end, use
the joining bars to tie them together and then attach
R-Hang bars to the array and hoist it into place. Use
a single RHANG-VA101H bar for two cabinets,two
for 3 to 5 cabinet horizontal arrays and more for even
larger horizontal arrays.
Note that the RHANG-VA101H flying hardware
accommodates only the 22.5 degree VA / VAX101-22
You should not attempt to use it with the other Varia
array modules.
Warning:
The actual rigging of loudspeakers suspended from a
truss or from a ceiling is a serious undertaking that is
beyond the scope of this document. It should be done
only by qualified and experienced professionals using
only load rated hardware.
We strongly recommend that you have your design
reviewed and approved by a licensed structural engi-
neer who can also verify the suitability of the building
attachment points.
Renkus-Heinz is not responsible for any non
Renkus-Heinz products or for any misuse of
Renkus-Heinz products.
Typical Horizontal Array
Page 10
Point Source Array Modules
R-HANG-VA101H