Brocade FCX Series Hardware Installation Guide - Manual (Page 31)

Port status LEDs (Continued) TABLE 11
LED Condition Status
SFP(1F~4F)
Link or Activity
On/Flashing Green The SFP port has established a valid 100/1000 Mbps link.
Flashing indicates the port is transmitting and receiving user
packets.
Off A link is not established with a remote port.
SFP+(1F~4F)
Link or Activity
On/Flashing Green The SFP+ port has established a valid 10 Gbps link. Flashing
indicates the port is transmitting and receiving user packets.
Off A link is not established with a remote port.
FIGURE 22 System status LEDs
1. System status LEDs
System status LEDs TABLE 12
LED Condition Status
PS1
PS2
(Power Supply Status)
Green Power supply is operating normally. It is installed
properly and the power cord is attached to a power
source.
Amber Power supply fault. The power supply may not be
installed properly.
Off Power off or failure.
Diag
(Diagnostic)
Flashing Green System self-diagnostic test in progress.
Green System self-diagnostic test successfully completed.
Amber System self-diagnostic test has detected a fault.
(Blower, thermal or any interface fault.)
Product Overview
Brocade FCX Series Hardware Installation Guide 29
53-1003077-01