Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) User Manual
Page 171
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide
147
53-1003031-02
show mpls lsp [name lsp_name][detail|extensive]
1
Examples
Case 1: link protection requested
Brocade# show mpls lsp name t1
LSP 1, to 10.44.44.44
From: 10.33.33.33, admin: UP, status: UP, tunnel interface(primary path):
tnl0
Times primary LSP goes up since enabled: 0
Metric: 0
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: no, active: no
Setup priority: 7, hold priority: 0,
.......
Fast Reroute: facility backup desired, link protection desired
Backup LSP: DOWN (CSPF fails: no bypass LSP found)
.......
.......
Case 2: Link protection not requested
LSP 1, to 10.44.44.44
From: 10.33.33.33, admin: UP, status: UP, tunnel interface(primary path):
tnl0
Times primary LSP goes up since enabled: 0
Metric: 0
Maximum retries: NONE, no. of retries: 0
Pri. path: NONE, up: no, active: no
Setup priority: 7, hold priority: 0,
.......
Fast Reroute: one-to-one backup desired, node protection desired
Backup LSP: DOWN (CSPF fails: no bypass LSP found)
.......
......
History
Release
Command history
Multi-Service NetIron Release 05.6.00 The command output now contains additional information indication link
protection or node protection.
Related
commands
None.
up:
Displays if the primary path is currently UP.
active:
Displays if the primary path is currently active.
Setup priority:
The configured setup priority for the LSP.
hold priority:
The configured hold priority for the LSP.
Fast Reroute:
The method of Fast Reroute configured for this LSP. Currently only one-to-one backup is
available.
Backup LSP:
Displays if the backup LSP is UP or DOWN.
Output field
Description