Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 847)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 823
53-1003031-02
Configuring 6VPE
9
CE-A1 Configuration
1. OSPFv3 Configuration
CE-A1(config)# ip router-id 110.110.110.1
CE-A1(config)# ipv6 router ospf
CE-A1(config-ospf6-router)# area 1
CE-A1(config-ospf6-router)# exit
2. Interface Configuration
CE-A1(config)#interface ethernet 1/1
CE-A1(config-if-e10000-1/1)# enable
CE-A1(config-if-e10000-1/1)# ipv6 address 3000:1::1/64
CE-A1(config-if-e10000-1/1)# ipv6 ospf area 1
CE-A1(config-if-e10000-1/1)# exit
PE-1 Configuration
1. VRF Configuration
PE-1(config)# vrf red
PE-1(config-vrf-red)# rd 1:1
PE-1(config-vrf-red)# ip router-id 120.120.120.2
PE-1(config-vrf-red)# address-family ipv6
PE-1(config-vrf-red-ipv6)# exit
PE-1(config)#
PE-1(config)# ipv6 router ospf vrf red
PE-1(config-ospf6-router-vrf-red)# area 1
PE-1(config-ospf6-router-vrf-red)# exit
PE-1(config)# interface ethernet 1/1
PE-1(config-if-e10000-1/1)# enable
PE-1(config-if-e10000-1/1)# vrf forwarding red
PE-1(config-if-e10000-1/1)# ipv6 address 3000:1::2/64
PE-1(config-if-e10000-1/1)# ipv6 ospf area 1
PE-1(config-if-e10000-1/1)# exit
2. OSPF Configuration
PE-1(config)# router ospf
PE-1(config-ospf-router)# area 0
PE-1(config-ospf-router)# exit
3. Loopback address Configuration
PE-1(config)# interface loopback 1
PE-1(config-lbif-1)# ip address 1.1.1.1/32
PE-1(config-lbif-1)# ip ospf area 0
PE-1(config-lbif-1)# exit
4. IPv4 address Configuration
PE-1(config)# interface ethernet 1/2
PE-1(config-if-e10000-1/2)# enable
PE-1(config-if-e10000-1/2)# ip address 10.10.10.1/24