Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 317)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 293
53-1003031-02
show mpls lsp_p2mp_xc
1
show mpls lsp_p2mp_xc
Displays hardware forwarding information
Syntax show mpls lsp_p2mp_xc in_label
Parameters in_label Specifies the MPLS input label value.
Command
Modes
Privileged EXEC mode
Usage
Guidelines
The show mpls lsp_p2mp_xc command displays information about the forwarding information of
hardware that is allocated for the point-to-multipoint (P2MP) cross-connect.
Command
Output
The show mpls lsp_p2mp_xc command displays the following information:
Output field Description
IN-LABEL The incoming MPLS label value.
XC# The XC index allocated for this instance.
FID The FID resource allocated for a particular entry.
MVID The MVID resource allocated for a particular entry.
IN-PORT The port where the traffic arrives.
NUM_OUT_SEGS The number of branches used by this instance.
BRANCH-ID The branch ID used by this instance.
OUT-LABEL The outbound MPLS label value.
OUT-PORT The router port through which the device reaches the next hop for this
route path.
NH-ID The next hop index used by this instance.
DIT The downstream interface table (DIT) ID used by this branch.
TSI The tunnel start interface (TSI) ID used by this branch.
Examples The following example displays hardware forwarding statistics on a Brocade MLX Series device:
Brocade# show mpls lsp_p2mp_xc
P2MP XC TABLE:
TOTAL USED = 2
IN-LABEL XC# FID MVID IN-PORT NUM_OUT_SEGS
1159 0 0a00a 106 65535 1
1160 1 0a00b 107 65535 1
Brocade# show mpls lsp_p2mp_xc 1159
TOTAL OUT_SEGS under the given in_label = 1
BRANCH-ID OUT-LABEL OUT-PORT NH-ID
0 0 14 6
Event History -
Tue Aug 14 02:21:54 2012 P2MP BRANCH ADD
Tue Aug 14 02:21:54 2012 P2MP XC ADD