Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 337)

Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 313
53-1003031-02
show mpls ldp
2
Example
(config-mpls-ldp)# show mpls ldp
Label Distribution Protocol version 1
LSR ID: 10.14.14.14, using Loopback 1 (deleting it will stop LDP)
Hello interval: Link 5 sec, Targeted 15 sec
Hold time value sent in Hellos: Link 15 sec, Targeted 45 sec
Keepalive interval: 5 sec, Hold time multiple: 7 intervals
Keepalive timeout: 40 sec
Load sharing: 4
Inbound FEC filtering prefix-list: list-in
Outbound FEC filtering prefix-list: list-out
Tunnel metric: 0
FEC used for auto discovered peers: current 129, configured 129
End of LIB: Disabled, Receive label silence time: 1000 ms
Graceful restart: disabled
History
Release Command history
Multi-Service NetIron Release 05.600 The output of show mpls ldp command is modified to accommodate the
out-bound FEC filter configuration. The prefix-list is displayed as (does not
exist) when the given prefix-list is not created in system.
Multi-Service NetIron Release 05.500 This command was enhanced to display the label withdrawal delay setting.
Related
commands
show mpls ldp [[database [A.B.C.D/filtered]][fec [prefix /summary/vc]][interface [ethernet/po
/tunnel/ve]][neighbor [A.B.C.D/detail]][path A.B.C.D][session [A.B.C.D/brief/detail]][statistics]
[targeted-peer A.B.C.D][tunnel [A.B.C.D/brief/detail/out-interface]]]
Tunnel metric Displays information to decide whether LDP or RSVP is the preferred method
for BGP next-hop resolution.
Graceful restart Provides the show GR setting and the status of the forwarding state hold
timer with the remaining time when it is running.
Label withdrawal delay How long the device waits before sending a label withdrawal message for a
FEC to a neighbor.
Command output Description