Brocade Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide (Supporting R05.6.00) - Manual (Page 397)

Brocade# show mpls config
router mpls
policy
traffic-eng isis level-2
ingress-tunnel-accounting
ldp
label-withdrawal-delay 30
session 10.7.7.2 key 2 $LSFVPW9iIQ==
session 10.7.7.3 key 2 $LSFVPW9iIQ==
bfd
min-tx 50 min-rx 50 multiplier 3
mpls-interface e3/3
ldp-enable
admin-group 2
mpls-interface e3/17
rsvp-authentication 2 key $LSFVPW9iIQ==
Multi-Service IronWare Multiprotocol Label Switch (MPLS) Configuration Guide 373
53-1003031-02
LDP over RSVP (for transit LSR only)
2
Syntax: show mpls config
Configuring a targeted peer address
A Brocade device does not send a targeted Hello message in response to receiving a targeted Hello
message from a peer that is not configured as a L2VPN peer. In the case when a L2VPN peer is not
configured on a Brocade device, and the user would like to enable support for LDP over RSVP, the
user must specify the IP address of the peer to bring up a targeted session. To trigger a targeted
session that is set up on the egress router of an RSVP tunnel, enter the targeted-peer command
under the MPLS LDP configuration.
Brocade(config)# router mpls
Brocade(config-mpls)# ldp
Brocade(config-mpls-ldp)# targeted-peer 10.10.10.10
Syntax: [no] targeted-peer ip-address
The ip-address variable specifies the IP address of the targeted peer. To disable the configuration,
enter the [no] form of the command.
NOTE
A targeted peer address is not configured on the ingress router of the RSVP tunnel because
configuring LDP tunneling for the LSP automatically brings up a targeted session.
Displaying targeted peer addresses
To display a list of configured peer addresses, enter the show mpls ldp targeted-peer command on
the CLI as shown in the following example.
Brocade# show mpls ldp targeted-peer
Peer_address
10.2.2.2