Power cords (japan, denan), General specifications, Power cords (japan, denan) general specifications – Brocade 7800 Extension Switch Hardware Reference Manual User Manual
Page 48
Power cords (Japan, Denan)
ATTENTION
Never use the power cord packed with your equipment for other products.
General specifications
The following table lists the general specifications for the Brocade 7800.
General specifications
TABLE 11
Specification
Description
Configurable port types
The GbE ports can be VE_Ports or VEX_Ports.
The Fibre Channel ports can be E_Ports, EX_Ports, FL_Ports, or F_Ports.
System architecture
Nonblocking shared-memory Extension Switch
System processors
PowerPC 440EPx, 667 MHz CPUGoldenEye2 switch ASICCavium CN5470
750 MHz processorBlaster FPGA
ANSI Fibre Channel protocol
FC-PH ( Fibre Channel Physical and Signalling Interface standard)
Modes of operation
Fibre Channel Class 2 and Class 3
Fabric initialization
Complies with FC-SW-3 Rev. 6.6
FCIP (IP over Fibre Channel)
Complies with FC-IP 2.3 of FCA profile
Aggregate Extension Switch I/O
bandwidth
A total 268 Gbps:
• 256 Gbps if all 16 FC ports are running at 8 Gbps, full duplex
• 12 Gbps if all 6 GbE ports are running at 1 Gbps, full duplex
Port-to-port latency
Less than 2 microseconds with no contention (destination port is free)
Power cords (Japan, Denan)
48
Brocade 7800 Extension Switch Hardware Reference Manual
53-1001350-05