Standalone installation for a brocade 6520, Rack installation for a brocade 6520, Brocade 6520 configuration – Brocade 6520 Hardware Reference Manual User Manual

Page 22: Providing power to the switch

Advertising
background image

10

Brocade 6520 Hardware Reference Manual

53-1002705-02

Standalone installation for a Brocade 6520

2

Standalone installation for a Brocade 6520

Perform the following steps to install the Brocade 6520 as a standalone unit.

1. Unpack the Brocade 6520 and verify the items listed on

“Items included with the Brocade

6520”

on page 5. Verify the items are present and undamaged.

2. Apply the adhesive rubber feet. Applying the rubber feet onto the switch helps prevent the

switch from sliding off the supporting surface.

a. Clean the indentations at each corner of the bottom of the switch to ensure that they are

free of dust or other debris that might lessen the adhesion of the feet.

b. With the adhesive side against the chassis, place one rubber foot in each indentation and

press into place.

3. Place the switch on a flat, sturdy surface.

4. Provide power to the switch as described in

“Providing power to the switch”

on page 10.

ATTENTION

Do not connect the switch to the network until the IP address is correctly set. For instructions on how
to set the IP address, refer to

“Brocade 6520 configuration”

Rack installation for a Brocade 6520

Follow the installation instructions shipped with the appropriate rack mount kit:

Fixed Rack Mount Kit Installation Procedure

Mid-Mount Rack Kit (Switch) Installation Procedure

Slide Rack Mount Kit Installation Procedure

Brocade 6520 configuration

Once you have set up the Brocade 6520 in a rack or as a standalone switch, it is time to give it
power and a basic configuration. If you are going to use the Brocade 6520 in a single-switch setup,
you can use EZSwitchSetup to complete the basic configuration.

Refer to the EZSwitchSetup CD, included with the Brocade 6520, for more information. You can
also use the Brocade 6520 EZSwitchSetup Quickstart Guide.

If you do not want to use EZSwitchSetup, follow the instructions in the rest of this section.

Providing power to the switch

Perform the following steps to provide power to the Brocade 6520.

Advertising