Serial port specifications, Access gateway default port mapping, Access gateway default port – Brocade 6505 Hardware Reference Manual User Manual
Page 50: Mapping
Serial port specifications
The serial port is located on the port side of the switch. The Brocade 6505 uses an RJ45 connector for
the serial port. An RJ45-to-DB9 adapter is also provided with the switch.
NOTE
To protect the serial port from damage, keep the cover on the port when not in use.
The serial port can be used to connect to a workstation to configure the switch IP address before
connecting the switch to a fabric or IP network. The serial port’s parameters are fixed at 9600 baud, 8
data bits, and no parity, with flow control set to None.
Serial cable pinouts
TABLE 12
PIN
Signal
Description
1
Not supported
N/A
2
Not supported
N/A
3
UART1_TXD
Transmit data
4
GND
Logic ground
5
GND
Logic ground
6
UART1_RXD
Receive data
7
Not supported
N/A
8
Not supported
N/A
Access Gateway default port mapping
The following table lists the port mappings of F_Ports to N_Ports.
Serial port specifications
50
Brocade 6505 Hardware Reference Manual
53-1002449-04