LumaSense Technologies Pearl OEM Manual - Manual (Page 16)

Pearl User Manual Connections 16
3.1.1 Video Connection
The video connection on the Pearl OEM camera is made directly to the BNC Jack on the back
panel. Either connect a video cable with the BNC-to-RCA adapter, which is provided in the Pearl
OEM Camera Kits, or use a BNC cable to connect the Video-Out BNC Jack to a video input on a
monitor.
BNC Video Connector
Center Video
Ring Video Ground
3.1.2 RS232 Connection
A three position receptacle is used for the RS232
connections for TXD, RXD, and Ground. The
adapter supplied in the Pearl OEM Camera Kit has a
RS232 connector on one end. Use a standard RS232
cable to connect between the adapter and the host
computer.
RS-232 or Data Connector
1 RXD
2 TXD
3 GND
Inserting the RS232 connection into the three
position receptacle at the back of the camera.
3.1.3 Power and Video Connection
A four position plug provides a connection for power and video output. Connect the power lead
to a power supply capable of a voltage between 9 and 20 Volts. A DC power with video adapter
to 4 pin cable is provided in the Pearl OEM Camera Kit.
Power and Video Connector
1 Video
2 Video Ground
3 Power Ground
4 Power
Inserting the connection into the four position receptacle at
the back of the camera