1 configuring the ethernet card – Aztech Systems DSL9100R User Manual
Page 18
18
User Manual
User Manual
User Manual
User Manual
User Manual
4.1
Configuring the Ethernet Card
i)
Power on your DSL9100R.
ii)
From your Windows desktop, right-click on the
Network Neighborhood
icon. Select
Properties
.
iii)
From the
Configuration
tab, select
TCP/
IP-> 3Com EtherLink III ISA [3C509b-
TPO] in PnP mode
6
and click
Properties
.
(If you do not see a TCP/IP networking protocol, re-
install your Ethernet card.)
6 This guide uses 3Com EtherLink III ISA Ethernet Card as an example. Select the Ethernet
Card that is listed in your system.
iv)
Select the
IP Address
tab.
Select the option '
Specify an IP
address
'.
Enter the
IP Address
and
Subnet Mask
as given by
your System Administrator.
Click
OK
to save the
settings.
When prompted to restart,
click
Yes
.
Please proceed to verify the link between your Ethernet Card and DSL9100R.