RIKON Power Tools 30-251 - Manual (Page 10)

A
C
B
B
A
Figure 17
INSTALLING THE TABLE
1. Install the arm onto the table support with hex
bolt(A-Fig.16) and make sure the scale is on
zero position(B-Fig.16). If necessory, adjust the
hex socket screw (C-Fig.16) to lever the table
90 degree to the spindle.
Figure 18
REMOVING THE CHUCK
1. Open the chuck jaws as wide as possible to
prevent damage.
2. Lower the spindle until the slot in the spindle is
exposed. (Fig.14)
3. Position the table approximately 1/2” below the
extended chuck.
4. Turn the chuck until a through hole is exposed
in the spindle.
5. Insert the Key-drift provided into the slot.
(Fig.15)
6. Gently tap the key-drift with a mallet to release
the chuck.
B
A
Figure 15
Figure 14
10
2. Insert the table post (A-Fig.17) into the table
support bracket (B-Fig.17) as shown.
3. Tighten the locking lever (A-fig.18) onto the
table support bracket (B-Fig.18) and install the
table raising/lowering handle (C-Fig.18).
A
B
C
Figure 16