RIKON Power Tools 30-251 - Manual (Page 12)

Disconnect machine from the power source.
B A
12
Figure 23
TABLE ADJUSTMENTS
Raising and Lowering the Table
1. Loosen the column lock (A-Fig.23) on the table
support bracket (B-Fig.23).
2. Turn the crank to raise or lower the table to the
desired height.
3. Tighten the column lock (A-Fig.23).
The table can rotate 360 o by loosening the table lock
handle and turning to the desired position. (Fig. 24)
TILTING THE TABLE
1. Loosen the nut below the table. (Fig. 25)
2. Tilt table to desired angle.
3. A Tilt scale and pointer are provided on the bracket
to indicate the angle.
4. Tighten nut.
CHANGING SPINDLE SPEEDS
Figure 24
Figure 25
WARNING!
Figure 26
B
A
1. Turn off and disconnect the power to the Drill
Press.
2. Open belt cover.
3. Release the tension on the belt by loosening the
belt tension lock (A-Fig.26) and pull forward on
the motor (B-Fig. 26).
4. Choose the desired speed by referring to the
speed selection chart.