RIKON Power Tools 30-251 - Manual (Page 13)

A
B
13
SETTING THE SPINDLE LOCK
1. Loosen the depth stop collar lock (A-Fig.29) as
shown.
2. Lower the spindle to the desired depth. (Fig.30)
3. Turn the depth stop collar clockwise until the collar
stops (B-Fig.29).
4. Tighten the depth stop collar lock.
Figure 29
Figure 27
Figure 30
CHANGING SPINDLE SPEEDS CONT.
Figure 28
NOTE:
SETTING THE DRILL DEPTH
1. With the spindle in the up position, loosen the depth
stop collar lock (A-Fig.29) as shown.
2. Turn the depth stop collar clockwise until the
pointer reads the desired drill depth on the scale
(B-Fig.29).
4. Tighten the depth stop collar lock.
6. Place the belt on the pulleys in relation to the
speed chosen on the speed selection chart
starting with the motor pulley first. (Fig.27)
7. Push back on the motor until there is approxi
mately 1/2" deflection in the belt. (Fig.28)
8. Tighten the belt tension lock handle.
9. Close the belt guard.
10. Reconnect the Drill Press to the power.
Figure 30 shows the spindle in the locked
position.