RIKON Power Tools 30-251 - Manual (Page 9)

9
Figure 10
Figure 11
INSTALLING/REMOVING CHUCK AND
ARBOR
It is important that the chuck
and arbor are free of any grease or rust
protection. Use ordinary household grease
remover.
INSTALLING THE CHUCK AND ARBOR
1. Open the chuck jaws as wide as possible to
prevent any damage. (Fig.10)
2. Insert the arbor (A-Fig.11) into the chuck
(B-Fig.11) as shown.
3. Carefully insert the chuck and arbor assembly
into the spindle, making sure to align the flat part
of the arbor with the spindle. (Fig. 12)
4. Using a mallet or wood and hammer, drive the
chuck and arbor assembly into the spindle. This
will properly seat the chuck assembly on the
spindle. (Fig. 13)
5. Close the chuck jaws with the chuck key pro
vided.
NEVER HIT THE CHUCK ASSEMBLY
WITH A METAL HAMMER. This could damage the
chuck assembly or spindle.
Figure 12
IMPORTANT!
NOTE:
Open Chuck Jaws
Figure 13