Seca 515 - Manual (Page 30)

30 •
Automatic BMI calculation To determine the BMI, you have to record the patient's height and weight.
♦ After weighing, manually enter the height of the patient.
– Manually (see “Manually entering body size” on page 29)
– Via the seca wireless network (see “Transmitting body size via
seca wireless network” on page 29)
The BMI is automatically calculated and displayed.
Automatic switchover
of weighing range
The scale has 2 weighing ranges. In weighing range 1, there is a low
maximum capacity and a more precise division of the weight display. In
weighing range 2, you can use the maximum capacity of the scale.
After switching the scale on, weighing range 1 is active. If a particular
weight is exceeded, the scale switches automatically to weighing range 2.
To return to weighing range 1, proceed as follows:
♦ Completely remove the load from the scale.
The weighing range 1 is active again.
Printing partial results If the device is connected to a seca 360° wireless printer, you can print the
measured results directly.
1. Ensure that the seca 360° wireless printer is switched on and that
there is a seca 360° wireless connection.
The seca 360° wireless printer symbol on the touchscreen display
turns white.
NOTE:
If you uncertain of whether there is a
seca 360° wireless connection,
contact your administrator or hospital technician.
2. Press the change menu button.
The secondary menu appears.
3. Press the print button.
All measured results and entries available at this point are printed.