Seed Hawk 30 SERIES 2015 - Manual (Page 39)

SEED HAWK ® 2015 30 SERIES OPERATOR’S MANUAL – DOMESTIC 34
5.1 Function Keys
NOTE: Always use the pow-
er Key to turn the monitor
off. This puts the monitor
through a save process and
it will store any accumulat-
ed information or changed
settings to the non-volatile
memory. Cutting power to
the monitor by shutting off
the ignition may cause some
information to be lost or set-
ting changes to not be saved.
Power
Selector Knob and Toggle
Escape
Enter
Navigation Keys
ACK (Activate
Clutch Key)
Meter Rate
Screen
Soft Keys
Power: When the monitor is off, pressing the Power Key will turn the monitor
on. When the monitor is on, pressing and holding the Power Key for 5 seconds
will turn the monitor off.
Escape: Pressing the Escape Key while in any menu will exit without mak-
ing any changes. Many of the functions for entering and navigating around the
screen are duplicated by the controls.
For example; moving highlight bars and selection boxes can be done by pressing
the Up/Down/Right/Left Arrows or by using the Selector Knob. The function of
the Enter
Key is usually duplicated by pressing the Selector Knob as well. The
only time the Enter Key must be used instead of the Selector Knob is when
entering and saving values from drop down key pads on the screen.
Enter: Pressing the Enter Key will act as a “Select Key” or “Enter Key”, on any
highlighted menu selections.
Selector Knob and Toggle: This Selector Knob is used for navigation within
menus. Turning the Selector Knob clockwise or counter clockwise will change
highlighted menu selections. The Toggle is activated by pressing down on the
Selector Knob. The Toggle acts as a “Select Key” or “Enter Key”.
Navigation Keys: These keys are used for navigation within menus. By pressing
the desired direction key, the highlighted selection will change accordingly.