SHARKOON Rebel9 Aluminum U3 - Manual (Page 12)

12 REBEL9 ALU U3
4. Attach the optical device from both sides using the quick fasteners (fig. 13).
fig. 13
Note:
If you intend to transport the case we recommend securing (additionally) the installed
drives:
(Screws for 5.25" drive mounting)
5. Connect the optical drive to the power supply and the mainboard. (Put the front bezel back
onto the case.)
8. Installation of a 3.5" device
(1. Remove the case’s front panel by gently dragging it towards you.)
2. Dismantle the 5.25" front bezel from the mounting bay in which you intend to install the
drive by loosening its screws and pushing the bezel to the inside (fig. 14). Remove the quick
fasteners (fig. 15).
fig. 14 fig. 15
