SHARKOON Rebel9 Aluminum U3 - Manual (Page 13)

13 REBEL9 ALU U3
(Carefully take out an optionally present metal bezel covering the drive bay by using a
gripper.)
3. Screw the mounting angles to the 3.5" device from both sides (fig. 16).
fig. 16
4. Slide the 3.5" device with attached mounting rails into the case’s drive bay (fig. 17) and
screw it to the drive bay from both sides (fig. 18).
fig. 17 fig. 18
5. Connect the 3.5" device to the power supply and the mainboard.
6. Screw the 5.25" bezel with 3.5" opening into the front panel (fig. 19) and place it back onto
the case.
(5.25" bezel with 3.5" opening)
fig. 19
