Spectra Precision ProFlex 800 Web Server User Manual
Page 29
25
–
Internet Protocol: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.
–
Access Point: Enter the URL of the mobile
communication provider.
–
Access Point Login: Enter the login of the mobile
communication provider.
–
Password: Enter the password of the mobile
communication provider.
• Click on the
Configure button.
• Now please follow all the steps described in section
General Parameters on page 16 and then proceed with the
steps below.
• Still on the
Rover Setup page, in the Network pane, set the
following parameters:
–
Connection: Choose “Modem Ntrip Client - Port E”. As
a result, new fields appear in this pane that you should
set as instructed below:
–
Connect Now: Enable this option to allow the receiver to
establish the connection right after you have clicked
on
Configure.
–
Address, Port, Login, Password: Enter the information
allowing the receiver to connect to the NTRIP caster.
This information should have been passed on to you
earlier by the administrator of this service.
–
Load Source Table button: Click on this button after you
have entered the information about the NTRIP caster.
As a result, the list of available sources from this caster
appears just underneath. (See example below.)