Spectra Precision ProFlex 800 Web Server User Manual
Page 51
47
• Set the following parameters in the
Internal Modem/Device
Settings pane:
–
Power: Select “On”. Then choose whether the modem
should be turned on automatically or manually:
Automatic: The modem will be switched on or off
automatically when the rover is respectively turned on
or off.
Manual: The modem will be powered up only by going
through the
Connections > Bluetooth/Modem page and
setting the modem to “Power On” (or using the
$PASHS,MDM,ON command).
–
Automatic Connection: Check this option.
–
2G Only: Enabling this check box will limit the use of
the modem only if a 2G mobile communication
network is available in the working area. When it is
cleared, the modem will be allowed to operate either in
a 2G or 3G network, whichever is available.
–
Pin: 4- to 8-character pin code of the SIM card used in
the modem for GPRS operation.
• Set the following parameters in the
Internal Modem/GPRS
Mode Settings pane (the mobile communication provider
you are using should be able to give you all this
information):
–
Internet Protocol: Choose the Internet protocol (TCP or
UDP) allowing the modem to perform an Internet
connection.
–
Access Point: Enter the URL of the mobile
communication provider.
–
Access Point Login: Enter the login of the mobile
communication provider.
–
Password: Enter the password of the mobile
communication provider.
• Click on the
Configure button.
• Click on
Base Setup > NTRIP Server and define the general
parameters of the base, as explained in section General
Parameters on page 35. Then proceed with the steps
below.
• Scroll down the page to display the NTRIP Server 1 frame.
In the
Connection field, select “External NTRIP Caster via
Modem”.
• Enter the information (
Connect Now, Address, Port,
Password, Mount Point) allowing the base to connect to the