Spectra Precision ProFlex 800 CORS - Manual (Page 57)

53
For more information on the various possibilities of routing
differential data to users, refer to the ProFlex 800 Web Server
Getting Started Guide or the ProFlex 800 Reference Manual.
NTRIP Server Via
Ethernet
• Click on Base Setup > NTRIP Server.
• Scroll down the page to display the “NTRIP Server 1”
frame. In the Connection field, select “External NTRIP
Caster via Ethernet”.
NOTE: If the Embedded NTRIP Caster firmware option is
activated, a third option is available (“Embedded NTRIP
Caster”) through which you can connect the NTRIP server
directly to the embedded NTRIP caster (instead of
connecting it to an external NTRIP caster).
• Enter the information ( Connect Now, Address, Port,
Password, Mount Point) allowing the base to connect to the
NTRIP caster (the server) to which it is supposed to deliver
its corrections.
NOTE: If you chose “Embedded NTRIP caster”, the
Address field has been unconditionally set to “localhost”.
• Enable Connect Now to allow the receiver to establish the
connection right after you have clicked on Configure.
• In the Message field, select the type of differential data the
base will deliver (ATOM, RTCM, CMR or DBEN). Following
your selection, you will see the detail of the selected data
by placing the cursor over the “I” sign on the right of this
field, as defined in
Data Output > Differential Messages.
• If you need to define a second NTRIP server, scroll down
to the “NTRIP Server 2” frame and resume the above
steps.
• Click on the Configure button to let the Web Server load all
your new parameters to the receiver.
Setting the
Embedded NTRIP
Caster
Remember the Embedded NTRIP Caster will be visible on the
Status and Configuration tabs of the Web Server only after the
NTRIP Caster firmware option ([C] option) has been activated
in the receiver.
• Click on Embedded NTRIP Caster > Settings
• Enable the Activation button to start the embedded NTRIP
caster (start-up will be effective after you have clicked on
the
Configure button).
• Enter the public IP address (or hostname) and IP port of
the NTRIP caster: