Alpine PXA-H800 - Manual (Page 34)

32
-EN
01GB06PXAH800.fm
ALPINE PXA-H800_EN 68-13530Z65-A (B5)
From a PC
Adjusting the Center Width (Center Width)
When you select “Music” for “Dolby Pro Logic II,” you can further
adjust the center width in the following steps. This function offers the
optimum vocal position by adjusting the center channel position
between the center speaker and the L/R speaker. (The adjustments
established in “Adjusting the Acoustic Image (BI-PHANTOM)”
(page 33) are ineffective while this function is activated.) (Initial setting:
“OFF”, “Level 0”)
1
Click [ON] for “Dolby Pro Logic II” - “Center Width.”
2
Click [ ] and select and click a level.
Level settings: Level 0 to Level 7
When the level becomes higher, the center channel
localization shifts from the center speaker toward both
sides.
• When the Center speaker is off in “Setting the Speaker System
(Output System Select)” (page 13)/ “Setting the Speakers (Speaker
Setup)/Setting the Subwoofers” (page 14), this item cannot be set.
Multi Channel Function Adjustment
Procedure
Make the adjustments described below in order to reproduce Dolby
Digital and DTS sound with greater accuracy.
In case of combining the Automatic adjustments, etc.
We recommend to make the Automatic adjustments before the Dolby
Surround adjustments.
Multi Channel Setup
These steps set multi channel playback.
1
Click [Multi Ch. Setup] for [Shortcut] tab in the main
menu.
The Multi Channel Setup screen is displayed.
• When you click [Multi Channel Manager] on the Function switching
tab, and then [Multi Channel Setup], the Multi Channel Setup screen
will also be displayed. Refer to “Operating the Function Switching
Tab” (page 7).
2
Set and adjust each item.
Setting item: Output Level/BI-PHANTOM/Rear Mix/Center
Bass Split/PCM Mode/Listening Mode/DVD
Level
Setting the 2-Channel Signal Playback Mode (2ch Playback
Mode) (page 30)
This sets the 2-channel signal playback mode.
Adjusting the Acoustic Image (BI-PHANTOM) (page 33)
Adjusting the acoustic image to achieve a sound as if the
center speaker were directly in front of the listener.
Setting the Linear PCM (PCM Mode) (page 34)
You can choose either 2ch or 3ch for the playback output of a
disc recorded on the linear PCM.
Mixing the Low Range Audio of the Center with the Front L/R
(Center Bass Split) (page 34)
Turning this feature on makes the audio signals emitted from
the front L/R speakers mixed with the center audio signals
(low range).
Mixing the Low Range Audio for the Rear (Rear Mix) (page 33)
Achieving smooth sound in the rear seat by mixing the front
audio signals with the rear speaker signals.
Achieving Powerful High Volume Sound (Listening Mode)
(page 34)
Achieving energetic sound with even greater power, like the
sound in a movie theater.
Adjusting the DVD Level (DVD Level) (page 34)
Adjust the volume signal level in each of the Dolby Digital,
Dolby Pro Logic II, DTC and PCM modes.
Adjusting the Speaker Volume Level (Output Level) (page 33)
Adjust each speaker’s volume so they are the same level.
Storing the Preset Values (Preset Store) (page 12)
Storing all the settings and adjustments made on the PXA-
H800 (not only the above settings/adjusts) in the memory.
01GB00PXAH800.book Page 32 Tuesday, February 8, 2011 9:04 PM