Alpine PXA-H800 - Manual (Page 37)

35
-EN
01GB07PXAH800.fm
ALPINE PXA-H800_EN 68-13530Z65-A (B5)
From the Commander
e About the Commander display
<Items that have been selected>
<Items that have not been selected>
Initial System Start-Up
If the system stops working properly, turn the ignition switch to off, and
then on again. If the system still does not work properly, reset the unit.
1
Press RESET switch with a ballpoint pen or similar
pointed object.
<Right side>
The system will be reset and restarted.
• Reset when power is off.
• Resetting does not erase the settings stored in the system.
Using with Ai-NET Connections
When the unit is connected to the head unit through Ai-NET, some
operations can be controlled with the head unit.
The following operations are controlled with the head unit. The
Commander and PC will no longer control these when the head unit is
connected.
• Turning Power On and Off (page 35)
• Switching the Sources (page 36)
• Adjusting Subwoofer/Balance/Fader/Volume (page 35, 36)
You can set Defeat (page 36) and Calling of the stored settings (Preset
Call) (page 37) with the head unit, Commander, or PC.
• Please refer to the Owner's Manual of the head unit.
Turning Power On and Off
When you turn on the power for the first time, to protect the speakers,
no sound is output until you select the system in “Setting the Speaker
System (System Select)” (page 37)/ “Setting the AUX Input System
(AUX Input Setup)” (page 39) and set them. First, set the speaker
system / input system.
You cannot turn power on/off from the PC. When an Ai-NET
compatible head unit is connected, the power of the unit is linked with
the power of the head unit.
1
Turn the ignition key to the ACC or ON position.
The power turns on.
2
Press and hold [SOURCE] for at least 2 seconds to
turn off the unit.
• Either switch will turn the power on.
• When the ignition key is turned to off, the power of the unit is also
turned off.
Audio Adjustment
1
Press the [Rotary encoder] repeatedly.
Select the adjusting mode.
SUBWOOFER*
1 NAVI LEVEL* 2 MX PLUS SETUP
(LEVEL ADJUSTMENT) * 3 BALANCE FADER
DEFEAT VOLUME SUBWOOFER
* 1 This is not displayed when the subwoofer is off.
* 2 This is not displayed when “Mixing Navi Audio Guidance (Navi Mix
Setup)” (page 41) is off.
* 3 This is not displayed when MX Plus is off.
2
Rotate the [Rotary encoder].
Select the level you want.
• Volume can be adjusted by rotating the rotary encoder without
selecting the Volume mode.
• If there is no operation within 5 seconds, the adjustment mode is
cancelled.
Adjust the subwoofer output (Initial setting: “00”).
Setting contents: 00 to 15
• When an Ai-NET compatible head unit is connected, the audio
settings are adjusted at the head unit and you cannot set them on the
unit itself.
Adjusts the Navigation audio guidance volume (Initial setting: “0 dB”).
Setting contents: -10 to +10 dB
Basic Operation
FUNC.
VIEW
Rotary encoder
SOURCE
RESET switch
Adjusting Subwoofer (SUBWOOFER)
Navigation Audio Volume Adjustment
(NAVI LEVEL)
01GB00PXAH800.book Page 35 Tuesday, February 8, 2011 9:04 PM