Aposonic A-S1602R25 - Manual (Page 30)

- 30 -
5.4 Display
In Menu display, press
▲▼◄► to change the
highlighted
option to
Display, and then press
ENTER to call up
Display dialog as shown.
There are several items
which can be adjusted,
including
Resolution,
Brightness, Contrast, Hue,
etc. Besides, Touch
panel
models
LP080S/LOF150B5A are also supported. The operations are as below:
▲▼ (Mouse: Click in the respective item)
Press these buttons to select the items.
+/-
Press these buttons to adjust the selected item.
MODE (Mouse: Left click)
Press this button to restore the items above to factory default values.
Touch Panel Model – the models supported are LP080S/LOF150B5A. Press
+/- buttons to change the supported model. If your touch panel is not listed, you
may still select one of the supported models, and use Calibration Settings to try to
calibrate the touch panel. However, it’s not guaranteed to be successful.
Calibration Settings.. – used to calibrate the touch panel. Press ENTER
(Mouse: Left click) in Settings.. to call up Calibration display for the touch
panel. Please follow the screen instructions to touch the center of mark
until successful or failed.
ESC (Mouse: Right Click)
Press this button to escape from this screen, and return to Menu display. If the
contents have been modified, a Save dialog will be shown to ask the user to save
the changes, press
ENTER to exit and save, ESC (Mouse: Right Click) to exit
without saving.