Aposonic A-S1602R25 - Manual (Page 43)

- 43 -
Goto Preset – to define the preset position to go to for the “Camera to go”
Camera in last field if motion is detected for this camera. For more details about
preset locations, please refer to
Chapter 7 PTZ Control .
Pre-record – to define how long before motion is detected this camera shall be
intensively recorded at Pre-record IPS. Press
+/- buttons to adjust the value
(0-10 seconds, discrete). Please note that the actual pre-record time may be
shorter than the value set if the total size of the pre-record pictures exceeds the
pre-record buffer size of the system.
Post-record – to define how long after motion is detected this camera shall be
intensively recorded at Event Record IPS. Press
+/- buttons to adjust the value
(0 second - 60 minutes, discrete).
Alarm Out – to define which Alarm Output will be triggered when motion of this
camera is detected. Press
+/- buttons to select none (N/A) or one of the Alarm
Outputs (NC (1), NO (2)).
Buzzer – to activate the internal Buzzer or not when motion of this camera is
detected. Press
ENTER or +/- (Mouse: Left click) to check/uncheck this item.
The default setting is “ˇ ˇ ˇ ˇ” - checked.
Log – to log to event logs or not. Press ENTER or +/- to check/uncheck this
item. The default setting is “ˇ ˇ ˇ ˇ” - checked.
Screen Message – to display the event message on the screen or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “ˇ ˇ ˇ ˇ” - checked.
E-mail – to send the event e-mail to remote station or not. The e-mail will be
sent to the predefined receivers when the event is triggered. Press
ENTER or
+/- to check/uncheck this item. The default setting is “– – – –” - unchecked.
FTP – to send the recorded event video/audio files to FTP server or not. Press
ENTER or +/- to check/uncheck this item. The default setting is “– – – –” -
unchecked.
Detection Settings.. – used to setup the motion detection settings, including
detection area and sensitivity, when motion is detected for this camera.
Please
note that the detection area and sensitivity are also used for the Smart Search
information. There won’t be any Smart Search information stored outside
the detection area. So, it’s better to enable the whole area if the motion
detection for the camera is disabled (and only Smart Search is used).
Press
ENTER in Settings.. to call up Motion Detection Setup (as shown) for this
camera. In Motion Detection Setup, the video area is divided into many small
grids, and the area with
gray grids is the area which will be detected for motion ,