Aposonic A-S1602R20B User Manual
Page 40
- 40 -
the Save dialog is shown, press ENTER to exit and save, ESC
(Mouse: Right
Click)
to exit without saving.
Following is a brief description for each item and its specific operations:
Title – The title (Max. 8 characters) of this camera. Please follow the Text Input
Video Loss Settings.. – used to setup the action settings when video loss is
detected for this camera. Press ENTER
(Mouse: Left click)
in Settings.. to
call up Video Loss Setup display for the camera. Please refer to
for the details.
Motion Detection – whether the motion detection of this camera is enabled or not.
(Note : this field has no effect for the Smart Search information.)
Press
ENTER
or +/-
to check/uncheck this item. The default setting is “ˇ” - checked.
Motion Settings.. – used to setup the motion settings,
used for Motion Detection
or Smart Search
, for this camera. Press ENTER
(Mouse: Left click)
in
Settings.. to call up Motion Setup display for the camera. Please refer to
for the details.
Please note that if the Motion Detection is disabled, the
default factory motion settings should work fine for Smart Search.
Covert – covert or not. If the camera is covert, the video of this camera can only
be seen if the user has logged in as Administrator. Press ENTER
or +/-
(Mouse:
Left click)
to check/uncheck this item. The default setting is “–” - unchecked.
Call By Event – whether to switch the monitor to the video of this camera if
certain event occurs for this camera. There are 4 options, including Off, Motion,
Alarm, Both (Motion & Alarm). Press +/- buttons to select one.
Dwell Time – the dwell time if Call By Event is set to Motion, Alarm, or Both.
Press +/- buttons to adjust the value (3-60 seconds, discrete).
Audio – the AUDIO IN corresponding to this camera. The audio data for the
selected AUDIO IN will be recorded with the video data for this camera. Press
+/- buttons to select none (N/A) or AUDIO Inputs (1, 2). The default setting is
“N/A”.
Record Quality – the record quality for this camera. Press +/- buttons to select
the value (1-9, with 1 the lowest (rough) quality, 9 the highest (fine) quality).
Event Record IPS – the IPS (Images Per Second) for this camera if certain event
(Motion, Alarm) occurs for this camera. This camera will be recorded at this
rate for Post-record time since the event occurs. (Please refer to the following
sections for Post-record time.) Press +/- buttons to select the value (0 – 25 (PAL)