Fire-Lite IPDACT Configurator Quick Guide - Manual (Page 11)

STEP 3
If the connection is successful, the “Quick Install” configuration screen appears.
Contrariwise, an error message appears indicating the problem. Two situations could
arise:
• The IPDACT release is not compatible with the application.
Fig. 15
• The user password is invalid:
Fig. 16
STEP 4
If the LAN has a DHCP server you must fill in the next parameters in the “Quick
Install” screen (see Fig. 5):
• Check the Enable DHCP client box: This configures the device to use
DHCP to get an IP address and gateway from a DHCP server in the LAN.
•
Account Number
: This is the IPDACT account number that identifies the
subscriber and can be up to 8 digits long.
•
Main VisorALARM IP address and Backup VisorALARM IP address: IP
addresses for the main and backup VisorALARM receivers.
•
UDP Port
: the receivers’ UDP port where the IPDACT sends alarms and
supervision messages.
Dm378-Iv3 11