Fire-Lite IPDACT Configurator Quick Guide - Manual (Page 5)

Dm378-Iv3 5
STEP 5
If the LAN does not have a DHCP server you must fill in the next parameters:
• Uncheck the Enable DHCP client box: This configures the device to use a
static IP address and gateway.
•
IPDACT IP Address : A static IP address for the device.
•
IPDACT Mask : IP subset mask the IPDACT pertains to.
•
IPDACT Gateway
: This parameter is the IP address for the router accessing
Internet.
•
Account Number
: This is the IPDACT account number that identifies the
subscriber and can be up to 8 digits long.
•
Main VisorALARM IP address and Backup VisorALARM IP address: IP
addresses for the main and backup VisorALARM receivers.
•
UDP Port
: the receivers’ UDP port where the IPDACT sends alarms and
supervision messages.
•
Auto-register password : This is the registration password that the IPDACT
will use to connect to the VisorALARM and to obtain its configuration
settings.
STEP 6
Click on the ‘Configure’ button. This sends and saves the above parameter values in
the IPDACT and restarts the device.
From this moment the IPDACT starts trying to connect to the VisorALARM to
complete registration and starts operating.
While the IPDACT is in the auto-registering process LED A remains flashing in green.
When the registration is completed, LED A stops flashing and LED E lights up in
green.