GW Instek GLA-1000 Series User Manual - Manual (Page 47)

Trigger Setup
47
Trigger Setup
This chapter describes how to configure the triggering conditions.
Signal triggering
condition setup
Set the condition individually ....................................... 48
Set conditions for multiple channels ........................... 49
Reset all trigger conditions .......................................... 50
Bus triggering
condition setup
Operator (Trigger condition) ........................................ 52
Reset all trigger conditions .......................................... 52
General triggering
properties setup
Trigger level ................................................................. 53
Trigger Count ............................................................... 54
Trigger Page ................................................................. 54
Trigger position ............................................................ 56
Trigger delay ................................................................ 56
Enable Trigger
function setup
Enable Qualifier ........................................................... 58
Enable Period ............................................................... 59
Delay Start Point .......................................................... 59
Trigger output
signal
Trigger Output Signal ................................................... 61