Bios configuration screen, Figure 4-2. modifying setup parameters screen – Ampro Corporation Single Board Computer 700 User Manual
Page 64
Chapter 4
BIOS Setup
58
Reference Manual
ReadyBoard 700
BIOS Configuration Screen
Ampro Setup Utility for ReadyBoard 700, SWxxxxxx
Use Arrow keys to change menu item, use Page Up/Down to modify. Esc to exit.
(C) Copyright 2004, Ampro Computers, Inc. - http://www.ampro.com
[Date & Time]
> Date
Oct 2004<
Time 10:24:34
[Drive Assignment]
Drive A 1.44 MB, 3.5”
Drive C
HDD on Pri Master
Drive D
Drive E
CDROM
Boot 4th
Boot 5th
08
Drive B (none)
(none)
(none)
Drive F (none)
Drive G
(none)
[Boot Order]
Boot 1st Drive A:
Boot 2nd Drive C:
Boot 3rd
(none)
(none)
Help for Date
The Date & Time fields are updated
in real-time.
When you make a change, the CMOS
is updated immediately.
Any changes made to Date & Time
fields will be saved even if you
discard changes at exit.
Figure 4-2. Modifying Setup Parameters Screen
•
Date & Time
♦
DATE (mm:dd:yyyy) – This requires the alpha-numeric entry of the calendar month (3), day
of the month (2), and all 4 digits of the year, indicating the century plus year (08 Oct 2004).
♦
Time (hh:mm:ss) – This requires 24 hour Clock setting in hours, minutes, and seconds
•
Drive Assignments
♦
Drive A – [none], [360kB, 5.25”], [1.2MB, 5.25”], [720kB, 3.5”], [1.44MB, 3.5”],
[2.88MB, 3.5”], or [USB Floppy]
NOTE
If USB Boot Support is [Disabled], the USB Floppy selections are invalid
and Drive B must be set to [none]. See Table 4-2 Floppy Drive Setting.
♦
Drive B – [none], [360kB, 5.25”], [1.2MB, 5.25”], [720kB, 3.5”], [1.44MB, 3.5”],
[2.88MB, 3.5”], or [USB Floppy]
NOTE
If a CompactFlash device is used in the system, it is always
configured as [HDD/CF Sec Master or Slave] as Drive C or D.
♦
Drive C – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave],
[CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master],
[HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]
NOTE
The BIOS does not support a break in the drive order, that is, Drive C
can not be listed as [none] when the boot device is Drive D.
♦
Drive D – [none], [HDD on Pri Master], [CDROM on Pri Master], [HDD on Pri Slave],
[CDROM on Pri Slave], [HDD/CF on Sec Master], [CDROM on Sec Master],
[HDD/CF on Sec Slave], [CDROM on Sec Slave], [USB HDD], or [USB CDROM]