Ampro Corporation Single Board Computer 700 - Manual (Page 66)

Chapter 4 BIOS Setup
60 Reference Manual ReadyBoard 700
♦ Boot 3
rd
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
♦ Boot 4
th
– [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
♦ Boot 5 th – [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
♦ Boot 6 th – [none], [Drive A], [Drive B], [Drive C], [Drive D], [CDROM], [Alarm], or [Reboot]
NOTE The default Boot order is, A, C, CD-ROM, and the BIOS will start its search for a
bootable device in drive A, then C, then CD-ROM. If no bootable device is found, the
screen will display “No Bootable Device Available” and the boot process will stop,
allowing you to select from: R – for Reboot, or S – for Setup.
If you do not choose R or S, the boot process stops, until you intervene, unless you have
selected [Reboot] as an option.
•
Drive and Boot Options
♦ Floppy over Parallel – [Disabled] or [Enabled]
• If [Enabled], this option selects the Floppy Drive instead of the Parallel port on the shared
connector.
• If [Disabled], this option selects the Parallel port instead of the Floppy Drive on the shared
connector.
♦ Floppy Seek – [Disabled] or [Enabled]
♦ Hard disk Seek – [Disabled] or [Enabled]
♦ Floppy Swap – [Disabled] or [Enabled]
♦ Boot Method – [Boot Sector] or [Windows CE]
Boot Sector is the traditional method for booting the system. If [Windows CE] is selected, the
BIOS attempts to load the NK.BIN file from the root directory of each boot device.
♦ Primary IDE Cable – [Auto], [40 Wire], or [80 Wire]
Setting these fields to [Auto], causes the BIOS to query the attached IDE device to determine
the type of IDE cable used. If the BIOS detects [40 wire], or you select it, the BIOS will not
use UDMA-66 or faster mode when sending signals to/from the IDE device.
♦ Secondary IDE Cable – [Auto], [40 Wire], or [80 Wire]
♦ Secondary Master ATA mode – [LBA], [Physical], or [Phoenix]
This default option (LBA - Logical Block Address) could be used on any IDE device, including
CompactFlash cards. However, this option specifically allows you to select between the
existing formats used to format your CompactFlash card as the Secondary Master device.
♦ Secondary Slave ATA mode – [LBA], [Physical], or [Phoenix]
This default option (LBA - Logical Block Address) could be used on any IDE device, including
CompactFlash cards. However, this option specifically allows you to select between the
existing formats used to format your CompactFlash card as the Secondary Slave device.
NOTE These options allows you to use any one of the three common formats
available for CompactFlash cards without having to re-format the
CompactFlash card before using it on the ReadyBoard 700. The LBA
(Logical Block Address) is set as the default format because it can
handle larger drives and is the newest format available, but may not be
the one used to format your CompactFlash card. The other common
formats that may be encountered are the Physical (below 512MB) or
Phoenix (physical above 512MB) formats.