INOR PROFIPAQ-L - Manual (Page 21)

21
4.1.4 Device information
Figure 18 ProfiSoft Device Information.
Device Information :
Profile Ident Number: Select PROFIBUS Profile Ver 3.0 or Manufacture Profile.
Write locking: Software write protection.
Memory Check: Check the EEPROM status at startup (this increases the startup time).
Tag: Text field can be used in any way. A recommended use is a s a unique label for a field
device in the plant.
Descriptor: Text that is associated with the Field Device.
Device Message: Text that is associated with the Field Device.
Restart device: Starts the device with the new values in EEPROM.
Software Revision: This revision corresponds to the software or firmware that is embedded
in the Field Device.
Device Serial Number: Uniquely identifies the field (read only).
Device Install Date: Date on which the device was installed.
Device Address: The PA address for the device (se Change Address for changing the
address).
Hardware Revision: Revision that corresponds to the electronics hardware of the Field
Device (read only).
Sensor Input Peak Value: Sensors highest/lowest peak value. Shows the transmitters
measured process Max/Min value when on-line. Press Reset button to reset the selected
channels Max and Min values.