INOR PROFIPAQ-L - Manual (Page 7)

7
2.3 Short form Data (complete data in chapter Specifications)
Power supply 9 – 32 VDC
Isolation Input/Output 1500 VAC
Output ProfIbus PA Profile v. 3.0 Class A&B
Operating temperature ProfIPAQ-H/-HX -40 - +85 °C / -40 - +185 °F
ProfIPAQ-L -20 - +70 °C / -4 - +158 °F
2.3.1 Ex Data (also see certificate and control drawings)
ProfIPAQ-H / -H/D ProfIPAQ-HX / -HX/D
ATEX Approval
Gas II 3G Ex nL IIC T4-T6 II 1G Ex ia IIC T4-T6
Dust II 3GD Ex nL T 100°C II 1G/2D Ex ia IIC T 100°C
ProfIPAQ-H/ -H/D is intended to be connected to a standard power supply (Class 2) with
maximum supply voltage to the transmitter of 30 VDC or a FNICO power supply / Segment
coupler, mounted outside the hazardous area. The data for the transmitter is:
Bus-port (connector 6 and 7)
Sensor port (1- 5) Comm.port
Ui = Vmax : 30 VDC Uo = Voc : 3,3 VDC Ui = Vmax : 8,0 VDC
Ii = Imax : no limit Io = Isc : 0,4 mA Ii = Imax : 450 mA
Pi = Pmax : no limit Po = Pt : 6,5 mW Pi = Pmax : 0,8 W
Ci : 1 nF Co = Ca : 500 µF Ci : 10 nF
Li : 10 µH Lo = La : 375 mH Li : 1 µH
For the ambient temperature:
T6: -40°C < Ta < +60°C / -40°F < Ta < +140°F
T5: -40°C < Ta < +75°C / -40°F < Ta < +167°F
T4: -40°C < Ta < +85°C / -40°F < Ta < +185°F
Dust: -30°C < Ta < +80°C / -22°F < Ta < +176°F
ProfIPAQ-HX / -HX/D is intended to be connected to a certified intrinsic safe power
supply / Segment coupler with FISCO data, mounted outside the hazardous area. The data
for the transmitter is:
Bus-port (connector 6 and 7) Sensor port (1- 5) Comm.port
Ui = Vmax : 17,5 VDC Uo = Voc : 17,5 VDC Ui = Vmax : 8,0 VDC
Ii = Imax : 380 mA Io = Isc : 56 mA Ii = Imax : 450 mA
Pi = Pmax : 5,32 W Po = Pt : 244 mW Pi = Pmax : 0,8 W
Ci : 1 nF Co = Ca : 166 nF Ci : 10 nF
Li : 10 µH Lo = La : 6 mH Li : 1 µH
For the ambient temperature:
T6: -40°C < Ta < +45°C / -40°F < Ta < +113°F
T5: -40°C < Ta < +60°C / -40°F < Ta < +140°F
T4: -40°C < Ta < +85°C / -40°F < Ta < +185°F
Dust: -30°C < Ta < +80°C / -22°F < Ta < +176°F