In-Situ Con TROLL PRO Operators Manual (purchased after 10 May 2012) - Manual (Page 6)

800-446-7488 6 www.in-situ.com
Getting Started
Probe Installation Requirements
Before making any wiring connections between the probes and the module, make sure
that the probes are set to their factory-default communication settings.
If you are using brand new probes, you do not need to do anything. If you are using pre-
configured probes, use Win-Situ 5 Software to reset the default communication settings.
1. Open Win-Situ Software and connect to the probe.
2. Change communication settings for the device by selecting Preferences, then
Comm Settings. Click the Reset All Devices button.
This returns the device communication settings to their serial communication defaults
(19200, 8, Even, 1, RTU, and Device Address 1).
Navigating Through the Menus
After the Con TROLL PRO is installed by a qualified professional using the Installation
Manual, you can begin operating the keypad. The DC model display turns on after you
push any button. The AC model display is always on when the unit is connected to
power.
Figure 1.1 Keypad and display window