In-Situ Con TROLL PRO Operators Manual (purchased after 10 May 2012) - Manual (Page 8)

800-446-7488 8 www.in-situ.com
Region UTC Value (± numeric value)
Australia Australian Capital
Territory
+10 (Daylight saving time +11)
Australia South +9.5 (Daylight saving time +10.5)
Australia Tasmania +10 (Daylight saving time +11)
Australia Western +8
Canada Central -6 (Daylight saving time -5)
Canada Eastern -5 (Daylight saving time -4)
Canada Mountain -7 (Daylight saving time -6)
Canada Yukon & Pacific -8 (Daylight saving time -7)
Canada Atlantic -4 (Daylight saving time -3)
Canada Newfoundland -3.5 (Daylight saving time -2.5)
England 0 hours (Daylight saving time +1)
USA Puerto Rico -4
USA Central -6 (Daylight saving time -5)
USA Eastern -5 (Daylight saving time -4)
USA Mountain -7 (Daylight saving time -6)
USA Arizona -7
USA Indiana East -5
USA Pacific -8 (Daylight saving time -7)
USA Alaska -9 (Daylight saving time -8)
USA Aleutian -10
USA Hawaii -10
4. Enter the date using the Up/Left arrow key. Select Enter to accept.
5. Enter the time using the Up/Left arrow key. Select Enter to accept.
6. It is optional to enter the installed location of the Con TROLL PRO. The location
name can contain up to 10 characters.
7. The Add Probe A screen appears. The name of the probe that is wired in this
position also appears. Select Enter to configure this probe.
8. The Add Probe B screen appears. The name of the probe that is wired in this
position also appears. If there is no Probe B, the display will tell you that no probe is
connected. Select Enter to configure this probe if it exists, or to proceed to the next
screen if it does not.
Figure 1.3 Probe and parameters view
9. Parameters are labeled A, B, and C. References to Probe C refer to the Con TROLL
PRO itself.
Using the View Function
1. Select the View option. An arrow will point to the first parameter.
2. Select View again to move the arrow to the next parameter.
3. With the arrow pointing to a parameter, use the Up and Down arrow keys to cycle
through all the available parameters on both sensors and the control module.