KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.4.08 to 4.11 - Manual (Page 22)

1-2
BOP HIPWR 070212
TABLE 1-2. BOP GENERAL SPECIFICATIONS
SPECIFICATION RATING/DESCRIPTION CONDITION
INPUT CHARACTERISTICS
a-c voltage nominal 230 Va-c
Single phase, or between two phases of a 3-
phase system
range 176 - 264 Va-c
Frequency nominal 50/60 Hz
range 47 - 63 Hz
Current 176 Va-c 9.5A (7.5A)* maximum
264 Va-c 6.4A (4.4A)* maximum
Power factor
Source 0.99 minimum
nominal output power
Sink 0.97 minimum
Efficiency 65% (56%)* minimum when sourcing
Switching frequency 70 KHz ±5% (50KHz ±5%)*
Active PFC Input for both Source and Recu-
peration (Sink)
EMC Compliance EN61326-1 (1997) Class A equipment
EMC immunity to: ESD EN61000-4-2 Electrostatic discharge
Radiated RF EN61000-4-3
EFT EN61000-4-4 Electrical fast transient/burst
Surges EN61000-4-5
Conducted RF EN61000-4-6
EMC emissions Conducted EN61000-3-2 harmonics
EN61000-3-3 fluctuation & flicker
Conducted EN55011/CISPR11 0.15 to 30 MHz
Radiated EN55011/CISPR11 30 to 1000 MHz
Leakage current 3.5 mA 230V a-c, 47-63 Hz
Insulation coordination Input Installation Category II For TN or TT power system
Overvoltage Category II
Output Installation Category II Maximum 300V common mode voltage
between output terminals and chassis ground.
Overvoltage Category II
Pollution degree 2
OUTPUT CHARACTERISTICS **
Type of stabilizer Voltage-current, 4-quadrant Switch mode
Switching frequency 100KHz ±5% Output Stage
Source adjustment
range voltage -100% to +100% of rating 0 to 50 deg C
current -100% to +100% of rating
Sink adjustment range voltage -100% to +100% of rating 0 to 50°C, recuperated energy is sent
back into line for general reuse
current -100% to +100% of rating
* BOP 6-125MG and BOP 10-75MG only.
** Output characteristics are for a single standalone unit. Output characteristics of identical multiple unit parallel/series configurations
are described in the Technical Manual associated with the applicable Cable Kit (see Table 1-5).