KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.4.08 to 4.11 - Manual (Page 9)

LIST OF
WARNINGS AND CAUTIONS
BOP 1KW OPR 7/2/12
G/(H Blank)
PAGE WARNING/CAUTION
energy from a constant current type load, set the current protection limits
of the BOP above the maximum current expected from the load.
3-26 CAUTION: Before Pressing
@
to enter the Saved Waveform Screen from the power-
up screen, perform the following steps to avoid unexpected voltages or
currents from previous settings being briefly applied to the load when the
waveform is first executed.
3-35 CAUTION: Pressing RESET will cause voltage transients to appear at the output
which may damage a connected load. Switch is recessed to prevent inad-
vertent activation.
3-53 CAUTION: When the serial port has received an XOFF, the error message -400, QUE
error will be placed in the queue to indicate the loss of transmitted infor-
mation due to a received XOFF character. When XON is received, the unit
will transmit all data in it's buffer followed by the exclamation character
(!). This (!) character is not part of any message from the BOP and indi-
cates the transmission buffer has been cleared and the BOP is idle.
4-11 CAUTION: If the CALIBRATE ZERO
!
function is available, perform this function
first, as it affects all other output calibrations.