KEPCO BOP-GL 1KW Operator Manual Firmware Ver.3.05 and higher - Manual (Page 33)

BOP-1K-GL 022814
1-15
1.6 EQUIPMENT SUPPLIED
Equipment supplied with the BOP power supply is listed in Table 1-3.
1.7 ACCESSORIES
Accessories for the BOP Power Supply are listed in Table 1-5.
1.8 SAFETY
Service must be referred to authorized personnel. Using the power supply in a manner not
specified by Kepco. Inc. may impair the protection provided by the power supply. Observe all
safety precautions noted throughout this manual (see listing on page E, preceding the Table of
Contents). Table 1-4 lists symbols used on the power supply or in this manual where applicable.
TABLE 1-3. EQUIPMENT SUPPLIED
ITEM FUNCTION PART NUMBER
Source Power Entry mating connector Mates with source power entry connector 142-0381 (Kepco) (IEC 320)
PAR/SER CONTROL - IN
mating connector Mates with PAR/SER CONTROL - IN port to allow
access to pins required for calibration 142-0488 (Kepco)
Mating Connector, Trigger Mates with Trigger port. 142-0527 (Kepco)
SP2501 (CUI Stack)
Mating Connector, Analog I/O Port
(15-pin DSUB Connector) Mates with connector for Analog I/O port A2A5J6
Dsub 15 pin hood
Dsub 15 pin male
108-0374
(Tyco-Amp 207470-1)
142-0449
(Amphenol 17S-DA15P)
TABLE 1-4. SAFETY SYMBOLS
SYMBOL Meaning
WARNING! RISK OF ELECTRIC SHOCK!
CAUTION: REFER TO REFERENCED PROCEDURE.
WARNING
INDICATES THE POSSIBILITY OF BODILY INJURY
OR DEATH.
CAUTION
INDICATES THE POSSIBILITY OF EQUIPMENT
DAMAGE.
!