Asus 1U Rackmount Barebone Server RS160-E3/PS4 - Manual (Page 35)

2 - 1 7 2 - 1 7 2 - 1 7 2 - 1 7 2 - 1 7 A S U S R S 1 6 0 - E 3 / P S 4 A S U S R S 1 6 0 - E 3 / P S 4 A S U S R S 1 6 0 - E 3 / P S 4 A S U S R S 1 6 0 - E 3 / P S 4 A S U S R S 1 6 0 - E 3 / P S 4
To install a fan or pair of system fans:
1. Hold the both sides on the fan, then
position the fan over a fan
compartment. Carefully insert the
fan, or pair of fans, until it fits in
place.
2. Connect the corresponding fan
cable from the connector on the
backplane board.
2.7 Removable components
You may need to remove previously installed system components when
installing or removing system devices, or when you need to replace defective
components. This section tells how to remove the following components:
1. System/Device fans
2. Power supply module
3. Optical drive
2.7.1 2.7.1 2.7.1 2.7.1 2.7.1 System/Device fans System/Device fans System/Device fans System/Device fans System/Device fans
The eight (8) system fans and two device fans come in a screw-less design.
To uninstall a fan or pair of system fans:
1. Disconnect the corresponding fan
cable from the connector on the
backplane board.
2. Hold the both sides on the fan, then
gently pull the fan out of the
compartment.