Legacy usb support [auto, Usb 2.0 controller [enabled, Usb 2.0 controller mode [hispeed – Asus 1U Rackmount Barebone Server RS160-E3/PS4 User Manual

Page 86

Advertising
background image

5 - 2 4

5 - 2 4

5 - 2 4

5 - 2 4

5 - 2 4

C h a p t e r 5 : B I O S s e t u p

C h a p t e r 5 : B I O S s e t u p

C h a p t e r 5 : B I O S s e t u p

C h a p t e r 5 : B I O S s e t u p

C h a p t e r 5 : B I O S s e t u p

Legacy USB Support [Auto]

Legacy USB Support [Auto]

Legacy USB Support [Auto]

Legacy USB Support [Auto]

Legacy USB Support [Auto]

Allows you to enable or disable support for legacy USB devices. Setting to
[Auto] allows the system to detect the presence of legacy USB devices at
startup. If detected, the USB controller legacy mode is enabled. If no legacy
USB device is detected, the legacy USB support is disabled.
Configuration options: [Disabled] [Enabled] [Auto]

USB 2.0 Controller [Enabled]

USB 2.0 Controller [Enabled]

USB 2.0 Controller [Enabled]

USB 2.0 Controller [Enabled]

USB 2.0 Controller [Enabled]

Allows you to enable or disable the USB 2.0 controller.
Configuration options: [Enabled] [Disabled]

USB 2.0 Controller Mode [HiSpeed]

USB 2.0 Controller Mode [HiSpeed]

USB 2.0 Controller Mode [HiSpeed]

USB 2.0 Controller Mode [HiSpeed]

USB 2.0 Controller Mode [HiSpeed]

Allows you to set the USB 2.0 controller mode to HiSpeed (480 Mbps) or
FullSpeed (12 Mbps). Configuration options: [FullSpeed] [HiSpeed]

Select Screen
Select Item

+-

Change Option

F1

General Help

F10 Save and Exit
ESC Exit

v02.58 (C)Copyright 1985-2004, American Megatrends, Inc.

BIOS SETUP UTILITY

Advanced

Number of seconds POST
waits for the USB mass
device after start
unit command.

USB Mass Storage Device Configuration

USB Mass Storage Reset Delay

[20 Sec]

U S B M a s s S t o r a g e R e s e t D e l a y [ 2 0 S e c ]

U S B M a s s S t o r a g e R e s e t D e l a y [ 2 0 S e c ]

U S B M a s s S t o r a g e R e s e t D e l a y [ 2 0 S e c ]

U S B M a s s S t o r a g e R e s e t D e l a y [ 2 0 S e c ]

U S B M a s s S t o r a g e R e s e t D e l a y [ 2 0 S e c ]

Allows you to set the number of seconds POST waits for the USB
mass device after start unit command. Configuration options:
[10 Sec] [20 Sec] [30 Sec] [40 Sec]

Advertising
This manual is related to the following products: