Recording video – Revo R4CMB-500 User Manual
Page 32
User’s Manual
26
Full Screen
2x2
Previous Camera
Next Camera
OSD
Full Screen
Selecting
(Full Screen) in the Mouse Display menu displays the cameras in the full screen mode.
2x2
Selecting
(2x2) in the Mouse Display menu displays the cameras in the quad (2x2) screen mode. It is the same as
pressing the individual camera buttons on the remote control in the full screen mode.
Previous Camera, Next Camera
Selecting
or
(Previous Camera or Next Camera) in the Mouse Display menu moves to the previous or next camera.
OSD
Selecting
(OSD) in the Mouse Display menu toggles OSD On and Off.
RECORDING VIDEO
Once you have installed the DVR following the instructions in Chapter 2 — Installation & Configuration, it is ready
to record. The DVR will start recording based on the settings you made in the Record setup screen.
Recycle On or Recycle Off. The factory default is Recycle On. It does this by recording over the oldest video once
the hard disk is full. Setting the DVR to Recycle Off causes it to stop recording once the hard disk is full.
Standard (CIF), High (Half D1) or Very High (D1). The factory default resolution is Standard. When set to Standard,
the DVR has a maximum recording speed of 120 ips. When set to High, the DVR has a maximum recording speed of
60 ips. When set to Very High, the DVR has a maximum recording speed of 30 ips.
Although you will be able to record without changing the unit from its original factory settings, you will want to take
advantages of the DVR’s many tools. See Chapter 2 — Installation & Configuration, Record Setup for detailed descriptions
of the recording mode options.
If the DVR was set up to record audio, it will record audio from up to four inputs when video is recording.
NOTE: Make certain you comply with all local and federal laws and regulations when recording audio.