SUOMY SR Sport - Manual (Page 24)

Do not expose the visor to heat to dry.
Do not use particular detergents (prepared solutions, creams, etc.) even if they are classified “specific for visors”, unless directly marketed by
Suomy.
Caution: do not clean the visor inside, because the ANTIFOG MIST RETARDANT could be damaged and thus affect the duration and
efficiency of the visor itself. Suomy therefore, cannot be held responsible if this should occur.
During cleaning operations, carefully handle the visor to avoid damaging the anti-scratch and anti-fog coating. Never use solvents, alcohol, fuels,
thinning substances or abrasive powders; these materials are aggressive and could affect the structural resistance of the polycarbonate or scratch
the surface of the visor with consequent reduction in the mechanical and optical properties.
Some colorings are made with Fluo UV paints that could be subject to the natural migration phenomenon with a drop in intensity. The
phenomenon could be enhanced when the helmet is exposed for long periods to a particularly intense light. However, this does not affect the
performances and the quality of SR SPORT.
Suomy therefore, cannot be held responsible if this should occur.
USER’S INSTRUCTIONS
RETENTION SYSTEM «D-RING» see figure 2
Insert the free end of the strap into the rings.
Pull until the strap fits tightly around the jaw.
After doing this, it should be impossible to slide out the helmet; verify that, by taking it from the back edge and rotating it towards the front, the
helmet cannot be removed and that it remains well fixed on your head.
If the helmet tends to come off or it moves freely on the head, pull the strap tight until the right pressure is reached and repeat test.
If after repeating the test you are not able to efficiently tighten the retention system, do not use the helmet.
Only after the strap has been adjusted tightly, fix the end part of the strap by fastening it with the press stud on the tongue. (see figure 2).
22
Eng USE and MAINTENANCE