SUOMY SR Sport - Manual (Page 31)

adheres along the entire length of the visor.
Fasten the central screw (G).
Lift the visor until it is completely opened.
Fasten the lower screw (H).
Reassemble the fastening screw of the visor as indicated in the previous paragraphs.
Repeat the operations on the opposite sides.
VISOR MECHANISM – replacing the visor see figure 11
Removing the mechanism
After removing the visor as indicated in the paragraphs above, loosen and remove the screws (G, H); then remove the shell mechanism.
Fitting the mechanism
The mechanisms are not interchangeable. Before proceeding it is necessary to identify the correct assembly side; the mechanisms
are identified by a letter stamped on the back side (L: left side with helmet on – R: right side with helmet on)
Position the mechanism on the shell, insert the screws tightening them.
After fitting the parts verify that the mechanisms are positioned correctly and tightly fixed
to the shell. Then fit the visor and adjust it as specified in the above paragraphs.
After fitting the mechanism verify that the visor is tightly fixed to the helmet, that it rotates
freely and that it locks correctly into the locking positions.
If this doesn’t happen and the rotation mechanism of the visor doesn’t work correctly, do
not use the helmet and contact authorized Suomy personnel only.
29
USE and MAINTENANCE Eng
figure 11
G
H